Tutorial

! How To Open Your Realme 7 For Repair Or Modification




Essential Prerequisites

Before embarking on this disassembly journey, it’s crucial to gather the necessary tools and establish a clean, well-lit workspace. A precision prying tool, commonly called a spudger, is essential for carefully detaching components without scratching the phone’s delicate surface. An appropriate set of screwdrivers, including a Pentalobe screwdriver for the bottom screws and a Phillips head for internal components, is also indispensable.

Realme  Disassembly & Teardown  How to Open Realme   Prime Telecom
Realme Disassembly & Teardown How to Open Realme Prime Telecom

Power Down and Secure the Phone

For safety reasons, it’s absolutely essential to power down your Realme 7 entirely before attempting to open it. Locate the power button, typically on the right side of the phone, and hold it down for a few seconds. A menu will appear; select “Power off” and wait for the phone to shut down completely. Additionally, remove any external accessories like cases or screen protectors to avoid obstructing the disassembly process.

How to Open Realme  /  Pro Back Panel  Realme  Disassembly  Realme   Teardown
How to Open Realme / Pro Back Panel Realme Disassembly Realme Teardown

Locating the SIM Card Tray

The first step involves removing the SIM card tray. This tray often houses the SIM card(s) and might also accommodate a microSD card for expandable storage. Look for a small hole on the side of the phone, usually near the bottom edge. Insert the pointed tip of the spudger into the hole and gently apply pressure to eject the tray. Once the tray pops out slightly, carefully pull it out with your fingers.

Realme  Disassembly / Realme  Teardown  All Internal Parts of Realme    How to Open Realme
Realme Disassembly / Realme Teardown All Internal Parts of Realme How to Open Realme

Removing the Back Cover

The back cover of the Realme 7 is secured using a combination of clips and adhesive. The spudger comes into play again here. Begin by carefully inserting the spudger’s thin edge between the frame and the back cover, preferably at the bottom corner where the clips are often located. Gently pry the spudger upwards, maintaining minimal pressure to avoid damaging the clips or scratching the back cover. Once a small gap is created, slide the spudger along the sides, gradually prying the back cover loose.

Remember: Patience is key here. Excessive force can easily crack the back cover or damage the delicate internal components.

Caution: Fingerprint Sensor and Cables

As you continue separating the back cover, be mindful of the fingerprint sensor cable that connects the fingerprint sensor on the back to the motherboard inside the phone. This cable is usually fragile and can be easily torn if not disconnected properly. Locate the connector where the cable attaches to the motherboard and gently pry it loose with the spudger’s tip.

Disconnecting Battery and Other Flex Cables

Once the back cover is detached, you’ll be greeted by the phone’s internal components. The most prominent will likely be the battery. Locate the battery connector, a small socket on the motherboard, and carefully disconnect it with the spudger’s tip. There might be other flex cables connecting the back cover components like the volume buttons or cameras to the motherboard. Identify their connectors and disconnect them meticulously using the same technique.

Remember: Take pictures of the cable placement before disconnecting them. This will serve as a valuable reference during reassembly to ensure everything is reconnected correctly.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button